Solids control

Features:

– Adjustable single deck with 4 panel screens

– Loop isolators

– 58.5 square feet of screen area

– Basket powered by two 2.5HP, 3-phase 230/460V 60Hz explosion proof Vimarc Vibrator motorsVibrator motors.

Features:

– SSS orbital motion

– Hard rubber shock mounts

– 20 square feet of screen area

– 4’ x 5’ hook strip screens

– Powered by a 3HP 3-phase 230/460V 60Hz explosion proof belt-driven motor.

Features:

– DSS orbital motion

– Hard rubber shock mounts

– 40 square feet of screen area

– 4’ x 5’ hook strip screens

– Powered by a 3HP 3-phase 230/460V 60Hz explosion proof belt-driven motor.

Features:

– SSS orbital motion

– Hard rubber shock mounts

– 9 square feet of screen area

– 3’ x 3’ hook strip screens

– Powered by a 2HP 3-phase 230/460V 60Hz explosion proof belt-driven motor

Features:

– Features a FS300 linear-motion shale shaker with a variety of possible desilter/desander cone arrangements manifolded above the screen deck

– Space saving model that can flow up to 1000/GPM

Features:

– Ultra-tough Cast Iron gear box (nominal ratio 30:1)

– Precision-ground gear sets to eliminate backlash

– Helical-bevel gear box achieves the highest efficiency available.

– Available in 3HP to 30HP sizes

Features:

– Available in 4” and 6” sizes with butterfly valve, Venturi discharge nozzle, jet nozzle, tees, studs and a sack cutting table capacity up to 650/GPM.

Features:

– Available in 2” and 3” sizes with a swivel joint, handle and jet nozzle at the bottom to stir tanks with lengths to meet your tank depth requirements.

Features:

– Designed to prevent drilling fluid loss on the rig floor

– Reduce wash downs due to a slippery rig floor

– 6’ x 11-3/4”

– Made to fit drill pipe sizes from 2-3/8” to 5-1/2”

– Available in a 4’ mode

Features:

– Manifold constructed of 8” Sch 40 pipe mounted on an angle iron base

– 10” cones with grooved end inlets and overflows

– Desanding capacity from 500 to 1500/GPM.

Features:

– Manifold constructed of 6” Sch 40 pipe mounted on an angle iron base

– 4” or 5” cones with grooved end inlets and overflows

– Desilting capacity from 400 to 1280/GPM